![packet tracer activity 3.4.1.2 solution packet tracer activity 3.4.1.2 solution](https://i.ytimg.com/vi/7q1iqchZwxY/mqdefault.jpg)
- #Packet tracer activity 3.4.1.2 solution software
- #Packet tracer activity 3.4.1.2 solution password
- #Packet tracer activity 3.4.1.2 solution Pc
![packet tracer activity 3.4.1.2 solution packet tracer activity 3.4.1.2 solution](https://i.ytimg.com/vi/FGYs9dDajvM/maxresdefault.jpg)
If using a packet sniffer such as Wireshark is an issue, the Answers may wish to assign the lab as homework or perform a walk-through demonstration. It is recommended that permission be obtained before running Wireshark for this lab. Using a packet sniffer such as Wireshark may be considered a breach of the security policy of the school. Additional PCs on a local-area network (LAN) will be used to reply to ping requests.Īnswers Note: This lab assumes that the student is using a PC with internet access and can ping other PCs on the local area network.1 PC (Windows 7, 8, or 10 with internet access).In this lab, you will use Wireshark to capture ICMP data packet IP addresses and Ethernet frame MAC addresses. Wireshark is a useful tool for anyone working with networks and can be used with most labs in the CCNA courses for data analysis and troubleshooting. As data streams travel back and forth over the network, the sniffer “captures” each protocol data unit (PDU) and can decode and analyze its content according to the appropriate RFC or other specifications.
#Packet tracer activity 3.4.1.2 solution software
Wireshark is a software protocol analyzer, or “packet sniffer” application, used for network troubleshooting, analysis, software and protocol development, and education. Part 2: Capture and Analyze Remote ICMP Data in Wireshark Background / Scenario
![packet tracer activity 3.4.1.2 solution packet tracer activity 3.4.1.2 solution](https://itexamanswers.net/wp-content/uploads/2017/07/7.3.1.2.png)
– MOTD banner with the message Authorized Access Only!!
#Packet tracer activity 3.4.1.2 solution password
– VTY password of c1$c0 (where 0 is the number zero) – Encrypted secret password of itsasecret Switchport trunk allowed vlan 10,20,30,88,99 Use VLAN 99 as the native VLAN on the trunk ports.Restrict the trunk to only allow VLANs 10, 20, 30, 88, and 99.Assign the native VLAN 99 to the trunk port and disable DTP.Create, name, and assign VLANs according to the VLANs and Port Assignment Table.IP addressing and default gateway configuration, according to the Addressing Table.You are responsible for configuring S3 with the following requirements: On a third switch, you are responsible for assigning IP addressing to the Switch Virtual Interface, configuring VLANs, assigning VLANs to interfaces, configuring trunking, and performing basic switch security. In this activity, two switches are completely configured. Packet Tracer – Skills Integration Challenge Addressing Table